Table of Contents
Advertisement
Trouble Conditions
When a trouble condition is detected, the Trouble ( ) or System indicator will turn on, and the keypad will beep
every 10 seconds. Press the
( ) or System indicator will flash. The corresponding trouble will be represented by numbers 1-8.
LED/
Trouble Condition
DIGIT
1
Service Required
2
Loss of AC Power
3
Telephone Line Fault
4
Failure to Communicate
5
Sensor (or Zone) Fault
6
Sensor (or Zone) Tamper
7
Sensor (or Zone) Low Battery
8
Loss of Time & Date
Trouble Menu Acknowledgement
If the Arming Inhibit for All Troubles features is enabled, Trouble Menu Acknowledgement may be used. To use
this feature while in the Trouble Menu (
the system can be armed. An override event will also be generated and logged, thus identifying the user. To over-
ride open zones, use the Zone Bypass feature (
Alarm Memory
When an alarm occurs, the Memory or Sys em indicator (and Fire indicator, if applicable) will turn on.
To view which sensor(s) generated the al m, press
sensor number will flash (i.e. sensor 3).
For the LCD5500 keypad use the
Press
to exit. To clear the memory, arm and disarm the system.
If an alarm sounded while armed, the keypad will automatically go to alarm memory when you disarm the sys-
tem. In this instance, you should approach with caution, as the intruder may still be within the building/premises.
Door Chime (Entry/Exit Beeps)
To turn the door chime function on or off, press and hold the Chime key for 2 seconds or press
Access Code Programming
In addition to the Master Access Code, you can program up to 32 additional User Access codes. Press
your Master Access Code. The Program or System indicator will begin to flash, and the Armed ( ) indicator will
turn on.
Enter the 2-digit number to be programmed (i.e. 06 for user access code 6; enter 40 for the Master Access Code).
When using the LCD5500, use the
digit access code, or press
or press
to exit.
key to silence the beeps. Press
If the building and/or neighbourhood has lost electrical power,
the system will continue to operate on battery for several hours.
The system has detected that the telephone line is cut.
The system attempted to communicate with the monitoring sta-
tion, but failed. This may be due to Trouble 3.
The system is experiencing difficulties with one or more sensors
on the system.
The system has detected a tamper condition with one or more
sensors on the system.
If the system has been equipped with wireless ensors, one or
more has reported a low battery condi i n
If complete power was lost (AC and Battery), the time and date
will need to be re-programmed
), press
scroll keys to view the sensors in alarm memory.
keys to find the specific code and press
to erase it. When programming is complete, enter another 2-digit code to program
to view the trouble condition. The Trouble
Comments
t acknowledge and override the existing troubles, so
).
. The Memory or System indicator and corresponding
11
Action
Call for service
Call for service
Call for service
Call for service
Call for service
Call for service
Call for service
Re-program Time
& Date (page 9)
.
, plus
to select. Enter the new 4-
Hide quick links:
Advertisement
Table of Contents
