Table of Contents
Advertisement
Arming Error
An error tone will sound if the system is unable to arm. This will happen if the system is not ready to arm (i.e. sen-
sors are open), or if an incorrect user code has been entered. If this happens, ensure all sensors are secure, press
and try again.
Disarming (Turning Off /Unsetting)
Enter your access code to disarm anytime the system is armed (i.e. Armed ( ) indicator is on). The keypad will
beep if you walk through the entry door. Enter your code within _____ seconds to avoid an alarm condition
(please check with your installer to have this time programmed).
Disarming Error
If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this happens, press
and try again.
Stay Arming (Partially Turning On / Part Setting)
Stay arming will bypass the interior protection (i.e. motion sensors) and arm the perimeter of the system (i.e.
doors and windows). Close all sensors (i.e. stop motion and close doors). The Ready ( ) indicator should be on.
Ask your alarm company if this function is available on your system.
Press and hold the Stay key for 2 seconds and/or enter your Access Code and do not leave the premises (if your
installer has programmed this button). During the setting state (exit delay ac ve), the Armed ( ) and Ready ( )
indicators will turn on, and the keypad will sound one beep every three sec nds.
When the exit delay is completed, the alarm system is armed/set and thi i indicated on the keypad as follows:
the Ready ( ) indicator will turn off, the Armed ( ) indicator will remain on and the keypad will stop sounding.
The Armed ( ) indicator and Bypass or System indicator will tur on The system will automatically bypass certain
interior sensors (i.e. motion sensors).
NOTE: For SIA FAR listed panels, the Stay Arming Exit D lay will be twice as long as the Away Arming Exit Delay.
Re-activate bypassed zones
To fully arm the system when it has been armed in S y mode:
Press
at any keypad. The interior zones ar
ow armed.
NOTE: When the interior zones have been re-ac vated, you will not be able to enter areas protected by motion detec-
tors, or open doors and windows. To acces these areas, enter your [access code] and disarm the system.
Silent Exit Delay
If the system is armed using the
button (Programmable Function Key) or using the "No Entry" Arming
STAY
method (
[access code]) he audible progress annunciation (keypad buzzer) will be silenced and the exit
time will be doubled for tha ex p riod only.
Remote Arming and D sarming
The system can be armed and/or disarmed using the remote control device (wireless key) model DSC WS4939.
When arming the system by using the Arm button on the wireless key, the system will acknowledge the command
by sounding a single bell squawk and when disarming using the Disarm button on the wireless key the system will
acknowledge the command by sounding two bell squawks that can be heard from the exterior of the premises.
Emergency Keys
Press the
(F),
(A) or
(P) key for 2 seconds to generate a Fire, Auxiliary or Panic alarm. The keypad sounder
will beep indicating that the alarm input has been accepted and transmission to the central station is underway.
Ask your alarm company if the emergency keys are available on your system.
NOTE: The Fire keys can be disabled by the installer.
LED5511/LCD5511 Keypad
Press and hold both keys simultaneously for 2 seconds to send the following messages:
Fire Message,
Auxiliary Message,
Panic Message.
8
Hide quick links:
Advertisement
Table of Contents
