Chris-Craft Lancer 20 Owner's Manual page 152

Trailering
_________
_________
_________
_________
_________
_________
_________
_________
_________
_________
_________
_________
_________
Station someone to help direct.
_________
Back straight down the ramp.
_________
Stop with trailer wheels at waters edge.
_________
Secure tow vehicle with parking brake and wheel chocks.
_________
Station helper to hold bow and stern lines from the ramp.
_________
Tighten winch brake and release anti-reverse lock. Do not disconnect winch cable.
_________
If equipped release tilt latch.
_________
Allow boat to slide off trailer.
_________
Unhook winch cable from bow and rewind or secure trailer.
_________
Pull boat to appropriate location and secure.
_________
Return trailer tilt to horizontal and lock.
_________
Remove chocks and drive tow vehicle and trailer from ramp.
_________
When you are on the boat lower the engine(s) into the water. If necessary turn on engine room blower for a
few minutes to clear the engine compartment of fumes. Start the engine and allow to warm up. Depart the
area slowly.
When returning to the loading ramp prepare the boat before approaching the ramp.
E–4
PRE-LAUNCH CHECKLIST
Drain plugs – installed (first visual check)
Boat cover – removed
Wheel chocks – available
Equipment – loaded for proper trim
Bow and stern lines – fastened
Tiedowns – removed
Fuel tanks – full
Outboard or stern drive – tilted up and engine support removed (if applicable)
Check boat systems (engine room blower, bilge pumps, lights, etc.) – operational
Electrical connection to tow vehicle – unplugged
Trailer wheel bearings – cool
Ramp conditions, water depth, current – checked
Drain plugs – installed (second visual check)
LAUNCHING CHECKLIST
Chris-Craft