Getting Started - SeaDoo ZS05 User Manual

Getting Started

®
When you buy the SEA-DOO SEASCOOTER
battery is disconnected and needs to be charged. Follow the
safety cautions on pages 9 to 12 and charging instructions
on pages 13 to 16.
Using the SEASCOOTER ™ for swimming and snorkeling.
When swimming or snorkelling
SEASCOOTER GTI should be kept positively buoyant - this
™
is done by simply making sure the Buoyancy Chamber is
empty and fitted inside the Nose Cone.
To use the SEASCOOTER ™ for swimming or snorkeling
follow these instructions.
1. Charge the battery and install just before use.
2. Make sure that Vent Plug is closed.
®
3. Place the SEA-DOO SEASCOOTER
so the Handle, Outer Nose Cone and Nozzle fill with water.
4. When ready to set off, switch the Master Switch to the On
position shown in figure 2.
5. Pull and hold both Triggers to start the Propeller.
(There is a short delay before the Propeller begins to
rotate).
6. To stop the Propeller, simply release the Trigger.
7. Always turn the Master Switch off when out of the water.
5
™ GTI the
®
the SEA-DOO
™ GTI into the water
Shown in "ON" position
Rotate to turn "OFF"
8. Proper posture when using
SEASCOOTER GTI is important to achieve the
™
maximum speed - see figure 3 for the correct position of
®
the SEA-DOO SEASCOOTER
CAUTION
Do not dive deeper than you would normally when snorkeling,
to ensure you can get back to the surface safely.
6
Fig.2
®
the SEA-DOO
™ GTI when using it.
Fig.3