Club Car Cafe Express Owner's Manual page 19

For the convenience of the trained technician, there is a neutral lockout switch located on the seat support panel
under the seat (Figure 11). The neutral lockout switch has two positions, MAINTENANCE and OPERATE, which
are clearly marked.
When the switch is in the MAINTENANCE position, it will allow the technician to run the engine in the NEUTRAL
position to perform certain maintenance and/or repair functions. With the switch in this position, the vehicle will not
operate if the Forward/Reverse handle is placed in either the FORWARD or REVERSE position.
WARNING
• With the switch in the MAINTENANCE position and the engine running, the vehicle can move suddenly
if the Forward/Reverse handle is shifted or accidentally bumped. To prevent this, chock the front and
rear wheels and firmly set the park brake before servicing or leaving the vehicle.
NOTE: Be sure to return the switch to the OPERATE position after servicing the vehicle, or it will not run with the
Forward/Reverse handle in either the FORWARD or REVERSE position.
BED LATCH
CAUTION
• The canopy frame must be disconnected from the top of the windshield frame before raising the bed.
Failure to do so will result in vehicle or canopy damage.
The vehicle is equipped with a bed latch on the driver side of the vehicle (Figure 12). To lift the bed, remove canopy
pins, then pull the latch handle toward the rear of the vehicle and lift the bed.
To close the bed, lower it gently until the bed latch engages. DO NOT drop the bed. Connect the canopy frame to the
top of the windshield frame by installing the canopy pins.
WARNING
• Keep hands and fingers clear of crush area between the bed and the seat back support.
• Unload the refreshment center before lifting the bed.
NOTE: The vehicle is equipped with an automatically engaging prop rod (Figure 13), unless equipped with the
electric bed lift option.
2827
Figure 12 Bed Latch
2828
Figure 13 Prop Rod
CAFE EXPRESS Vehicle Owner's Manual
Controls and Indicators
Page 17