Volvo XC90 Installation Instructions Manual page 6

Volvo xc90 navigation system portable installation instructions

Hide thumbs Also See for XC90:

Installation instructions, accessories - Navigation system portable

Volvo Car Corporation Göteborg, Sweden

Assembling the holder

Illustration A

Install the spacer in the bottom of the holder.

Illustration B

Ensure that the holder's two screw turrets align between the small pins in the

oblong holes in the spacer. A click should be heard when the spacer is securely

in position.

IMG-282406

IMG-282409

Assembling the holder

Place the connector in the bottom of the hole. The guide hole (1) in the

connector's circuit board must align in the corresponding pin at the bottom of the

holder and the holes (2) in the circuit board must be over the holder's screw

turret.

IMG-282410

Assembling the holder

Take the small torx screws and carefully tighten the connector to the holder.

Ensure that the connector's circuit board is properly against the screw turret and

that there is no play.

Remove the butyl tape from the screws.

IMG-282411

31212529

Page 6 of 15