Chrysler Sebring 2010 Owner's Manual page 128

• After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 "Programming A Rolling Code
System."
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to Step 5 "Pro-
gramming A Rolling Code System."
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor. It is
NOT the button normally used to open and close the
door.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
3