Starting And Stopping - Jonsered CS 2255 Operator's Manual

As the chain brake is still activated the engine must return to
idling speed as soon as possible by disengaging the throttle
latch in order to avoid unnecessery wear on the clutch
assembly.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
Note! Pull the front hand guard towards the front handle. The
chain brake is now disengaged. Your saw is ready for use.
WARNING! Long term inhalation of the
!
engine's exhaust fumes, chain oil mist and
dust from sawdust can represent a health
risk.
• Never start a chain saw unless the bar, chain and all
covers are fitted correctly. See instructions under the
heading Assembly. Without a bar and chain attached to
the chain saw the clutch can come loose and cause
serious injury.

STARTING AND STOPPING

• The chain brake should be activated when starting. Se
instructions under the heading Start and stop. Do not drop
start. This method is very dangerous because you may
lose control of the saw.
• Never start the machine indoors. Exhaust fumes can be
dangerous if inhaled.
• Observe your surroundings and make sure that there is no
risk of people or animals coming into contact with the
cutting equipment.
• Always hold the saw with both hands. The right hand
should be on the rear handle, and the left hand on the
front handle. All people, whether right or left handed,
should use this grip. Use a firm grip with thumbs and
fingers encircling the chain saw handles.
Stopping
Stop the engine by pressing down the stop button.
– 21
English