Rear Panel Layout - ICON QConEX User Manual

Tips: DAW button could not be activated if a DAW software is running.
(Note: We will update Qcon EX firmware from time to time to support additional DAW apart from
the current existing list. Please check our official website to download and upgrade your Qcon EX
firmware).
Tips: Qcon EX will memorize your last selected DAW mode and re-enter the same mode few seconds
after it's been switched on. (i.e. DAW mode selection is not needed if last mode is being used.)

Rear Panel Layout

User A / User B RCA connectors
1
These RCA connectors are able to connect to foot pedals to activate your selected
functions. To set their parameters, select USER A and USER B parameters at Mackie
control mode.
USB port
2
Connect your Qcon EX to your Mac/PC via this USB port.
12V/5A power adaptor
3
Connect the provided power adaptor here.
(Note: Qcon EX is not able to work without the provided power adaptor connected.
The USB bus power is not able to provide sufficient power supply for Qcon EX.)
5
1
3 2