Inspecting Burners - Superior TF18NE Installation And Operation Instructions Manual

TOUCH PAD OPERATION
This touch control has only 3 buttons for con-
trolling manually the flame of the appliance
(see Figure 43).
The touch pad has:
1. Led display
2. ON/OFF button
3. UP button
4. DOWN button
With this control it is possible to turn on the
fire, turn off the fire and control the flame level.
LED Display
ON/OFF Button
UP Button
DOWN Button
Figure 43 - Touch Pad Control
Note: The touch pad includes a red LED
display light. If the LED remains on, the black
plug is connected upside down. Unplug, turn
over, and reconnect.
SWITCHING ON
To turn the system on just press the ON/OFF
button. The system will emit a beep and begin
the ignition process, which can take about
20 seconds. Once the start up process is
complete, the pilot flame is lit.
REGULATING THE FLAME LEVEL.
1. To increase the flame level, press the
up button (
the LED indicate that the system has
accepted the order, and the flame will
increase instantly (see Figure 59).
2. To decrease the flame level, press the
down button (
the LED indicate that the system has
accepted the order, and the flame will
decrease instantly (see Figure 59).
28
INSTALLATION
ON
OFF
). A beep and a flash of
). A beep and a flash of
www.SuperiorFireplaces.US.com
Continued
SWITCHING OFF
To switch off the fire, the ON/OFF button
should be pressed. After the system has emit-
ted a beep, the fire switches off.
WARNING: Do not convert
heater to use different fuel type.
Only use heater with fuel type
specified.

INSPECTING BURNERS

Check pilot flame pattern and burner flame
patterns often.
PILOT FLAME PATTERN
Figure 44 shows a correct pilot flame pattern.
Figure 45 shows an incorrect pilot flame pat-
tern. The incorrect pilot flame is not touching
the thermocouple. This will cause the thermo-
couple to cool. When the thermocouple cools,
the heater will shut down.
If pilot flame pattern is incorrect, as shown
in Figure 45.
• turn heater off (see To Turn Off Gas to Ap-
pliance, page XX
• see Troubleshooting, page XX
Note: The pilot flame on natural gas units will
have a slight curve, but flame should be blue
and have no yellow or orange color.
Thermocouple
Figure 44 - Correct Pilot Flame Pattern
(Your pilot may vary from pilots shown)
Thermocouple
Figure 45 - Incorrect Pilot Flame Pattern
(Your pilot may vary from pilots shown)
Pilot Burner
Pilot Burner
126818-01A