Troubleshooting - JVC EM42FTR Quick Start Manual

TROUBLESHOOTING

Problem

No Power




Poor or No Sound




Poor or No Picture




Poor Reception on

Some Channels



The Remote Control

does not work



TV Shuts Off


No CATV Reception


Closed Caption is not

activated
Emerald FTR Series QUICK START GUIDE
Make sure the power cord is plugged in.
The power is off; press Power button to turn on the TV.
Try another outlet.
Unplug the unit for an hour, and then plug it back in.
Press the VOL Up button on the remote control or adjust volume using the Power/Multi-Function
button on TV (see page 6 for details).
Press MUTE button on the remote control to ensure mute is not on.
The channel or cable TV broadcast is experiencing problems. Tune to another channel.
Check the TV audio settings and possible sources of interference.
The channel or cable TV is experiencing problems. Tune to another channel.
Make sure that channels are set into memory.
Check the antenna or cable TV connections.
Check for possible sources of interference.
The channel or cable TV broadcast is experiencing problems. Tune to another channel.
Make sure that channels are set into memory.
The network signal is weak. Adjust the antenna to receive a better reception
Check for possible sources of interference.
Batteries may be weak, dead, or inserted incorrectly.
Point the remote control directly at the IR sensor on the TV with an angle of 35 degrees.
Remove any obstacles between the remote control and the TV.
Remote control is out of range. Move closer to the TV.
Sleep timer is set.
Power is interrupted.
Check all cable TV connections.
Set the TV Mode in Channel menu.
The channel/program is not a closed caption broadcast. Try another channel.
Enable Closed Caption in the Menu.
Solution
Rev. 12/13