Assembling The Cutting Equipment - Jonsered GT2123 Operator's Manual

Assembling the cutting equipment

WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
Fitting the trimmer guard and trimmer
head
• Attach the cord cutter (A) to the trimmer guard using two
M5x16 screws, locking washers and nuts as shown.
C
D
• Fit the guard (B) to the gear housing (C) using the support
plate (D) and two screws.
• Turn the output shaft until one of the holes in the drive disk
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (E) in the hole to lock the shaft.
E
F
• Screw on the trimmer head (F) in the opposite direction to
the direction of rotation.
• Remove the locking pin.
10 –
English
ASSEMBLY
B
A