Dodge Viper SRT 2013 User Manual page 64

E LE C TR O NICS
• Simultaneously press and hold both the HomeLink
the hand-held transmitter button.
• Continue to hold both buttons and observe the indicator light. The HomeLink
will flash slowly and then rapidly after HomeLink
from the hand-held transmitter. Release both buttons after the indicator light changes
from slow to rapid.
• Press and hold the programmed HomeLink
NOTE:
• If the indicator light stays on constantly, programming is complete and the garage
door (or device) should activate when the HomeLink
• To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
Using HomeLink®
• To operate, press and release the programmed HomeLink
occur for the programmed device (i.e., garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the
device may also be used at any time.
• Your motorized door or gate will open and close while you are programming the
universal transceiver. Do not program the transceiver if people or pets are in the
path of the door or gate.
• Do not run your vehicle in a closed garage or confined area while programming the
transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO) which is
odorless and colorless. Carbon Monoxide is poisonous when inhaled and can cause
you and others to be severely injured or killed.
62
® button you want to program and
has received the frequency signal
®
® button and observe the indicator light.
buttons, repeat each step for each
®
WARNING!
button is pressed.
®
® button. Activation will now
indicator
®