Take Out Cassette Tape - JVC GR-D93US Service Manual

5.2

TAKE OUT CASSETTE TAPE

(1) Remove the Power Unit (battery or DC code) from the set.
(2) Remove 1 screw, and remove a plate (ADJ).
NOTE:
For more efficient operation, loosen and move the grip
belt prior to the procedure (2).
(3) Open the CASSETTE COVER till it is completely opened
and fixed.
(4) Attach a PVC tape as shown in the figure.
NOTE:
Be careful of cassette tape damage caused because the
CASSETTE HOUSING ASSEMBLY is moved upward at
the unloading end (EJECT mode).
(5) To set the SLIDE DECK ASSEMBLY to the unloading end,
apply DC 3V to the electrode (terminal) on the top surface
of the LOADING MOTOR ASSEMBLY that is seen through
a hole under the plate removed in the procedure (2).
NOTE:
Be careful not to attach grease or a similar substance to
the surface of the cassette tape on the tape transport
system.
(6) Wind the cassette tape by directly turning the REEL DISK
ASSEMBLY (SUP) from the backside of the SLIDE DECK
ASSEMBLY by using a sharp tool (Chip IC replacement
tool).
(7) Confirm that the cassette tape is completely wound, and
then peel off the PVC tape from the CASSETTE HOUSING
ASSEMBLY and take out the cassette tape.
NOTE:
To confirm that the cassette tape is completely wound,
confirm that one REEL DISK ASSEMBLY (TU) rotates
as you rotate the other REEL DISK ASSEMBLY (SUP).
(8) Make sure that grease or a similar substance is not
attached to the surface of the tape taken out in the
procedure (7). Similarly, also make sure that grease or a
similar substance is not attached on the MECHANISM
ASSEMBLY, especially the tape transport system.
1-20 (No.YF020)
(DC3V)
TAPE
LOADING MOTOR
ASSEMBLY
CASSETTE HOUSING
ASSEMBLY
REEL DISK
ASSEMBLY (SUP)
SLIDE DECK
ASSEMBLY
Fig.5-2-1
CASSETTE COVER