Table of Contents
Advertisement
• Press the SOLO LEVEL button in the
Studio/Solo Section and use the LEVEL
V-Pot to adjust the solo level in the Control
Room Output.
STUDIO/SOLO
MIXDOWN SOLO
RUDE SOLO
LIGHT
PFL SOLO
AFL SOLO
TALKBACK TO
STUDIO
LEVEL
By default, the solo signal is tapped from a
channel post-fader. This is useful if you want to
solo several channels and adjust the balance
between them. Sometimes it's useful to solo a
channel pre-fader so you can hear it even when
the fader is turned down (to find and eliminate
an annoying buzz, for example, or to set the
proper input sensitivity level on a channel).
• Press the SOLO PFL (Pre-Fader Listen)
button in the Studio/Solo Section to change
the solo function to pre-fader.
STUDIO/SOLO
MIXDOWN SOLO
RUDE SOLO
LIGHT
PFL SOLO
AFL SOLO
TALKBACK TO
STUDIO
LEVEL
Note: When switching from AFL to PFL, be
wary. If the fader is set below unity (the "U"
symbol), and you press the SOLO AFL button
in the Studio/Solo Section to turn it off (i.e.,
change to pre-fader), the solo signal will become
louder; much louder if the fader is below about
–5 dB. This could come as a rude surprise!
You may want to solo an aux send so you
can hear the signals being sent to an external
effect or floor monitor.
• Press the AUX button in the V-Pot Select
Section to select the Aux bus that you want
to solo.
CLEAR SOLO
SOLO LEVEL
STUDIO LEVEL
TALKBACK LEVEL
• Press the SOLO button in the Master V-Pot
Section to solo the selected Aux bus. The
signal is pre-fader (Aux Master V-Pot) by
default. The SOLO PFL button has no effect
when an aux send is soloed.
CLEAR SOLO
The MIXDOWN SOLO button in the Studio/
Solo Section allows you to solo channels in the
SOLO LEVEL
Main L-R output. When you solo a channel
with MIXDOWN SOLO turned on, it auto-
STUDIO LEVEL
matically mutes all the other channels, and
only the soloed channel can be heard. Soloing
TALKBACK LEVEL
additional channels unmutes them so they can
be heard in the L-R output.
Note: PFL and AFL SOLO have no effect when
MIXDOWN SOLO is active. You can monitor
the soloed channels in the Control Room by
selecting MASTER L-R in the Control Room
Section.
1-24
1-48
LEVEL TO TAPE
DIGITAL TRIM
AUX 1
AUX 2
AUX 3
AUX 4
MASTER
PAN
SOLO
General Guidelines
25
Advertisement
Table of Contents
