Tones And Alerts - NEC Conference Max Plus User Manual

10
To program Conference number
Press and hold until the Program icon appears on the LCD screen.
1. REDIAL/PROG
2. Press 5 to enter the Conference menu.
3. Press REDIAL/PROG .
4. Enter the phone number.
Note: To add a pause to the phone number, press and hold the pound (#) key. To add a dash
to the phone number, press and hold the 1 key.To add a space to the phone number, press and
hold the star key (*).
5. Press REDIAL/PROG to save the number. Press CLEAR to exit.
Note: If a number has already been programmed, use CLEAR to delete the old number
before entering the new number.
To program service center number
1. Press and hold the key until the Program icon appears on the LCD
REDIAL/PROG
screen.
2. Press 6 to enter the service center menu.
3. Press .
REDIAL/PROG
4. Enter the number you want the 0 key to dial.
Note: To add a pause to the phone number, press and hold the pound (#) key. To add a dash
to the phone number, press and hold the 1 key.To add a space to the phone number, press and
hold the star key (*).
5. Press to save the number. Press CLEAR to exit.
REDIAL/PROG
Note: If a number has already been programmed, use CLEAR to delete the old number
before entering the new number.
To program the Automatic Gain Control (AGC)/
Automatic Level Control (ALC) settings
1. Press and hold the REDIAL/PROG key until the Program icon appears on the LCD screen.
2. Press 8 to enter the AGC/ALC menu.The current setting
is displayed on the LCD screen.
3. Press REDIAL/PROG.The current setting flashes.
4. Enter the new setting. Refer to the table at right.
5. Press REDIAL/PROG to confirm selection. Press CLEAR
to exit.
Note:The default AGC/ALC setting is 1.
To restore factory defaults
1. Press and hold the key until the Program icon appears on the LCD
REDIAL/PROG
screen.
2. Press and hold the 9 key.The number 8 will be displayed across the LCD screen.
3. Press to confirm selection. Press CLEAR to exit.
REDIAL/PROG
NEC Conference Max Plus — User Options
Setting Speaker Microphone
AGC ALC
1 On On
2 Off
On
3 Off On
4 Off Off
NEC Conference Max Plus — User Options

Tones and alerts

Tone/Alert Description
Not powered If the base unit is not powered, you will hear a beeping sound
when you press the Phone key.
Confirmation A tone will play upon successful programming entry.
A tone will play if you attempt to do any of the following:
Reject
• enter an invalid programming entry
• use a speed dial key that has not been programmed
(One-Touch Conferencing or service center)
• enter a 45th digit when predialing
• enter a 17th digit for user phone number
• enter a 31st digit for speed dial key (One-Touch
Conferencing or service center)
Low Battery An alert will sound every 60 seconds when batteries require
charging and conferencing pod is in Phone mode.
An alert will sound every 30 seconds when conferencing pod is
Out of Range
too far from base unit and in Phone mode.
Paging
When the Page button on the base unit is pressed, the
conferencing pod will beep loudly for 30 seconds or until any
key on the keypad is pressed.
11