Table of Contents
Advertisement
Operating Instructions and Parts Manual
Assembly
tooLS requIreD For ASSeMbLy
Screwdriver
u
(2) Wrenches
u
hAnDLe ASSeMbLy
1. Slide handle into shroud holes until
the holes of the handle line up with
the holes of the tank bracket.
2. Insert and tighten screws to hold the
handle in place.
InFLAtIon hoSe ASSeMbLy
1. Thread the coil hose into the fitting
on the shroud. Use 2 adjustable
wrenches, as shown in Figure 10, to
tighten the connection.
2. Screw blow gun onto the end of the
coil hose.
Once the recoil hose and blow gun are
attached, make sure no pressure is in
tank before replacing. Recoil hose and
blow gun must be installed for unit to
operate properly.
Installation
LoCAtIon
When assembled, the tank must sit level
to allow the tank to drain properly.
It is extremely important to install the
compressor in a clean, well ventilated
area where the surrounding air
temperature will not be more than 100°F.
A minimum clearance of 18 inches
between the compressor and a wall is
required because objects could obstruct
air flow.
Do not locate the
compressor air inlet
near steam, paint spray, sandblast areas
or any other source of contamination. This
debris will damage the motor.
10
www.chpower.com
Figure 9 - handle assembly
Figure 10 - Inflation hose assembly
Advertisement
Table of Contents
