Fiat Ducato Owner's Handbook Manual page 145

❒ loosen one turn the bolts of the wheel
to change;
❒ turn the ring nut to extend the jack
partially;
❒ set the jack near the lifting support
close to the wheel to change in the
points shown in fig. 7a. For short
wheelbase versions with retractable
footboard, the jack shall be set in the
point shown in fig. 7b and shall be
suitably directed (45°) to avoid inter-
ference with the retractable foot-
board;
❒ warn anybody nearby that the vehicle
is about to be lifted. They must stay
clear and not touch the vehicle until
it is back on the ground.
144
fig. 7a
fig. 7b
The moving parts of the jack (screw and
joints) may also cause injury if touched.
Clean off any grease.
❒ loosen the bolts completely using the
wrench F-fig. 8 and remove the
wheel;
F0N0193m
fig. 8
❒ fit the spare wheel making the holes
G-fig. 9 coincide with the respective
pins H. Make sure the contact surfaces
between spare wheel and hub are
clean so that the fastening bolts will
not come loose;
❒ tighten the 5 fastening bolts;
❒ operate the ratchet wrench to lower
the vehicle and remove the jack.
F0N0194m
❒ fasten bolts completely, working in a
criss-cross fashion as shown in fig. 9.
F0N0167m