Baumatic BCI7030 User Manual page 24

IMPORTANT: Check that both the upper and lower doors open
and shut correctly, without fouling, after you have completed
the door reversal process.
After the door has been reversed, you should check
the door seal of the fridge and freezer door. Neither
seal should be creased or crushed; otherwise there
will be a gap between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
o Remove the pin of the
bottom right-hand hinge
and remount it on the
bottom left-hand hinge.
o Invert the plate cover of
the cabinet mounted on
the plate.
o Reassemble the
and doors working from
the bottom to the top 1
2 3.
hinges
24