General Specifications; Introduction; Locating And Mounting - Nortec GH Series Instaliation, User & Maintenance Manual

MODEL GH 200 SPECIFICATIONS
ALTITUDE
FUEL BLOWER INPUT ORIFICE STEAM MANIFOLD
AIR SHIPPING OPERATING
(FT) SPEED (BTU H) SIZE pRILL CAPACITY PRESS. IN ORIFICE WEIGHT WEIGHT
(MODEL) SI E) (LBS/HR) W.C. DIAMETER (LBS)
(LBS).
NORMAL NATURAL MAX 238,000 E 200 -0.2
I
1.062"
350
660
MIN (S,P) 119,000 E 100 -0.2 1.062"
(0-2000) GAS MIN (MC) 65,000 E 50 -0.2 1.062"
HIGH NATURAL MAX 214,000 E 180 -0.2 1.062"
350 660
MIN (S,P) 107,000 E 90 -0.2 1.062"
(2000-4500) GAS MIN (MC) 58,500 E 45 -0.2 1.062"
NORMAL PROPANE MAX 238,000 9 200 -0.2 1.062"
350 660
MIN (S,P) 119,000 9 100 -0.2 1.062"
(0-2000) (LP GAS) MIN (MC) 65,000 9 50 -0.2 1.062"
HIGH PROPANE
MAX
214,000 9 180 -0.2 1.062"
350 660
MIN (S,P) 107,000 9 90 -0.2 1.062"
(2000-4500) (LP GAS) MIN (MC) 58,500 9 45
-0.2 1.062"
MODEL GH 400 SPECIFICATIONS
ALTITUDE
FUEL BLOWER INPUT ORIFICE
(FT) SPEED
(BTUH)
SIZE
~DRILL
(MODEL) SI E)
NORMAL NATURAL MAX 476,000
MIN (S,P) 238,000
(0-2000) GAS MIN (MC) 65,000
HIGH
NATURAL MAX 428,000
MIN (S,P) 214,000
(2000-4500)
GAS MIN (MC) 58,500
NORMAL PROPANE MAX 476,000
MIN (S,P) 238,000
(0-2000) (LP GAS) MIN (MC) 65,000
HIGH PROPANE MAX
428,000
MIN (S,P) 214,000
(2000-4500) (LP GAS) MIN (MC)
58,500
GENERAL SPECIFICATIONS
INTRODUCTION
The NORTEC GH Series humidifier is a
completely new patented design based on leading
edge technology. The GH is designed to provide
clean steam humidification at an economical price.
E
E
E
E
E
E
9
9
9
9
9
9
Available for normal altitude (0-2000' elevation) or
for high altitude (2000-4500' elevation) applications.
LOCATING AND MOUNTING
GH Series humidifiers are designed to mount on a
suitable wall (GH 100 only), vertical surface, or floor.
The clearance dimensions shown in this manual are
for reference only and are the minimum required for
maintenance of the humidifier. Local and National
STEAM MANIFOLD AIR SHIPPING OPERATING
CAPACITY PRESS. IN ORIFICE WEIGHT WEIGHT
(LBS/HR) W.C. DIAMETER
(LBS) (LBS)
2 -
400
-0.2 1.062"
800 1200
200
-0.2
1.062"
50
-0.2
1.062"
360 -0.2 1.062"
800 1200
180 -0.2 1.062"
45 -0.2 1.062"
400 -0.2 1.062"
800 1200
200 -0.2 1.062"
50
-0.2 1.062"
360 -0.2 1.062"
800 1200
180
-0.2
1.062"
45 -0.2 1.062"
Codes should be consulted prior to final location and
installation of the humidifier. NORTEC cannot accept
responsibility for installation code violations.
1. Location of the humidifier should be below and
as close as possible to the steam distributor
location.
2. For front and side clearance requirements (for
access during installation, maintenance and
troubleshooting), see Figure #2.
3. DO NOT locate humidifier any further than
absolutely necessary from steam distributor
location. Net output will be reduced as a result
of heat loss through steam hose (see
Engineering Manual, Form # -163D). Also,
increased static pressure (over 12"
w.e.)
may
nec'essitate using a field installed extended
water trap.