Specifications - Pioneer VSX-49TX Service Manual

Audio/video multi-channel receiver
Hide thumbs Also See for VSX-49TX:
Table of Contents

Advertisement

VSX-49TX, VSX-47TX

8.2 SPECIFICATIONS

VSX-49TX :
Amplifier Section
Continuous average power output of
160 watts* per channel, min., at 6
ohms, from 20 Hz to 20,000 Hz with no
more than 0.09 %** total harmonic
distortion (front).
Continuous Power Output
Front ........ 130 W + 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Center .................... 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Surround ........... 130 W + 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Surr. back .......... 130 W + 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Audio Section
Input (Sensitivity/Impedance)
PHONO MM ......................................... 4.7 mV/47 kΩ
LINE ..................................................... 382 mV/47 kΩ
Phono Overload level (T.H.D.0.1 %, 1kHz)
PHONO MM ...................................................... 120 mV
Frequency Response
PHONO MM ..................... 20 Hz to 20,000 Hz ± 0.3 dB
LINE ....................................... 5 Hz to 100,000 Hz
Output (Level/Impedance)
LINE ...................................................... 382 mV/2.2 kΩ
Tone Control
BASS ..................................................... ± 6 dB (100 Hz)
TREBLE ................................................. ± 6 dB (10 kHz)
LOUDNESS ............................ +4/+2 dB (100Hz/10 kHz)
Signal-to-Noise Ratio (IHF , short circuited, A network)
PHONO MM ......................................................... 86 dB
LINE ................................................................... 105 dB
MULTI CHANNEL IN .... 103 dB(Channel Level: Bypass)
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
PHONO MM ......................................................... 83 dB
LINE ..................................................................... 93 dB
*
Measured pursuant to the Federal Trade Commission's
Trade Regulation rule on Power Output Claims for
Amplifiers.
** Measured by Audio Spectrum Analyzer.
Maintenance of External Surfaces
• Use a polishing cloth or dry cloth to wipe off
dust and dirt.
• When the surfaces are dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out
well, and then wipe again with a dry cloth. Do
not use furniture wax or cleaners.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this unit,
since these will corrode the surfaces.
180
+0
dB
–3
(at volume position -40dB)
Video Section
Input (Sensitivity) .......................................... 1 Vp-p/75 Ω
Output (Level/Impedance) ............................. 1 Vp-p/75 Ω
Signal-to-Noise Ratio .............................................. 70 dB
Frequency Response ...................... 5 Hz to 10 MHz
Component Video Section
Input (Sensitivity) .......................................... 1 Vp-p/75 Ω
Output (Level/Impedance) ............................. 1 Vp-p/75 Ω
Signal-to-Noise Ratio .............................................. 70 dB
Frequency Response ...................... 5 Hz to 40 MHz
FM Tuner Section
Frequency Range ............................ 87 .5 MHz to 108 MHz
Usable Sensitivity ......... Mono: 13.2 dBf, IHF (1.3 µV/75 Ω)
50 dB Quieting Sensitivity ......................... Mono: 20.2 dBf
Signal-to-Noise Ratio ................... Mono: 73 dB (at 85 dBf)
Distortion ........................................ Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity ................... 60 dB (400 kHz)
Stereo Separation ........................................ 40 dB (1 kHz)
Frequency Response ................... 30 Hz to 15 kHz (± 1) dB
Antenna Input ......................................... 75 Ω unbalanced
AM Tuner Section
Frequency Range ............................ 530 kHz to 1,700 kHz
Sensitivity (IHF , Loop antenna) ........................... 350 µV/m
Selectivity ................................................................. 25 dB
Signal-to-Noise Ratio ................................................ 50 dB
Antenna ........................................................ Loop antenna
Miscellaneous
Power Requirements ............................... AC 120 V, 60 Hz
Power Consumption ................................................ 710 W
Power Consumption in Standby mode ................... 0.65 W
AC Outlet
SWITCHED ...................................... 100 W (0.8 A) MAX
Dimensions .................... 440 (W) × 203 (H) × 472 (D) mm
5
(17-
/
16
Weight (without package) ................... 29.3 kg (64 lb 6 oz)
Furnished Parts
FM wire Antenna ............................................................. 1
AM Loop Antenna ........................................................... 1
AC Power Cord ................................................................. 1
"AA" IEC LR6 batteries .................................................... 4
Remote Control Unit ........................................................ 1
Touch Pen ........................................................................ 1
Cushion for Remote ......................................................... 4
Microphone ...................................................................... 1
U-shaped connectors ....................................................... 2
Operating Instructions ...................................................... 1
NOTE:
Specifications and the design are subject to possible
modifications without notice, due to improvements.
+0
dB
–3
+0
dB
–3
Stereo: 38.6 dBf
Stereo: 70 dB (at 85 dBf)
(W) × 8 (H) × 18-
9
/
(D) in.)
16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vsx-47txVsx-ax10i-g

Table of Contents