Akai 42” Operating Insructions page 5

Hold the power connector when removing the power cable:
Pulling the power cable itself may damage the wires inside
the cable and cause fire or electric shock.
Do not touch the connector with wet hands:
To avoid risk of electric shock.
Insert batteries in accordance with instructions:
Insert the batteries with correct polarities (positive
negative ).
Installing the batteries backwards may cause the battery to
leak and otherwise damage the remote control.
Do not block or cover the vents:
Blocking the vents may cause overheating and fire. Do not
install the product in a place with little or no ventilation.
Never cover the vents with towels, blankets or dusters.
Unplug the connector:
Unplug the power connector when the product will not be
used for a long time.
Always make sure the antenna system is properly grounded to provide adequate
protection against voltage surges and built-up static charges.(see Section 810 of
the National Electric Code.)
Electric service equipment
Ground clamp
Use extreme care to make sure you are never in a position where your body (or
any item you are in contact with, such as a ladder or screwdriver) can accidentally
touch overhead power lines. Never locate the antenna near overhead power lines
or other electrical circuits. Never attempt to install any of the following during
lightning activity:
a). an antenna system; or
b). cables, wires, or any home theater component connected to an antenna or
phone system.
ATTENTION
Ground clamp
Power service grounding
electrode system (NEC Art 250 Part H)
and
Antenna lead-in wire
Antenna discharge unit (NEC
Section 810-20)
Grounding conductors
(NEC Section 810-21)
Unplug the connector
Unplug the connector
5