D-Link DIR-615 User Manual page 39

Section 3 - Configuration
Wireless Mode:
Select one of the following:
802.11n Only - Select only if all of your wireless clients are 802.11n.
802.11 Mixed(g/b) - Select if you are using both 802.11b and 802.11g wireless clients.
802.11 Mixed(n/g/b) - Select if you are using a mix of 802.11n, 11g, and 11b wireless clients.
Bandwidth:
Select the Channel Width:
20MHz - Select if you are not using any 802.11n wireless clients. This is the default setting.
20/40MHz(Auto) - Select if you are using both 802.11n and non-802.11n wireless devices.
Short Guard Check this box to reduce the guard interval time therefore increasing the data capacity. However, it's less reliable and may
Interval:
create higher data loss.
Wireless Mac
This section allows you to configure the MAC address of a computer, and allow or deny its access to wireless.
Filter:
SSID: Use the drop-down list to select an SSID that has been configured in Wireless Network Name Setup.
Use the Configure Wireless MAC Filter Rules below drop-down list to select an universal MAC filter rule for the MAC
Wireless MAC
addresses listed in the fields below.
Filter Rule:
Enter the MAC address for the rule. The format should be xx:xx:xx:xx:xx:xx.
MAC Address:
D-Link DIR-615 User Manual 36