TELEFONICA Wireless Router Installation Manual page 12

PROBLEM
I do not have an icon for the wireless
client.
The client management application
does not show the network for my
router (the one that appears on the
label) as being one of the available
networks.
I cannot connect to the router wire-
less network.
12
Solutions to frequent problems (cont.)
REASON
Your wireless client is not correctly
installed, set up or configured.
The wireless network is disabled on the
router.
Your network identifier (SSID) is not
being correctly indicated when you
connect to it.
You have not correctly configured the
encryption used on your wireless net-
work when connecting to it.
The TCP/IP properties of your wireless
client are not configured to receive IP
via DHCP.
SOLUTION
Make sure that your wireless client is correctly installed
and enabled. More information is contained in the ma-
nual for the device itself.
Make sure that the wireless network for your router is
enabled: the WLAN/WPS indicator is lit up in green.
Check to make sure that you are using the same net-
work identifier (SSID) throughout the network. Re-
member that it is case sensitive, i.e. a distinction is made
between capital and small letters.
Check to make sure that you are using the same type
of encryption and the same key for all the network ele-
ments. Remember that if you are using WEP encryption,
you will have to select and configure the key number 1 in
the configuration for wireless clients.
Make sure that the TCP/IP properties of the network
adapter for your wireless client are configured to receive
the IP dynamically (via DHCP). Refer to the assistance
given in your operating system.