Table of Contents
Advertisement
Main Menu
Replacing Front Side Marker and
Position Light Bulbs
1. Use a phillips head screwdriver to
remove the screw from the top of
headlight assembly
2. Use a small flat blade screwdriver
to carefully pry the front edge of
the side marker light assembly
forward from the headlight lens.
Table of Contents
Move the side marker light
assembly forward until it pops out
of the body.
3. Remove the electrical connector
from the bulb holder by squeezing
the connector by the top and
bottom and pulling them apart.
4. Turn the bulb holder one-quarter
turn counterclockwise to remove it
from the lens.
5. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
6. Put the bulb holder back into its
hole in the lens, and turn it clock-
wise until it locks.
7. Plug the wire harness back onto
the bulb holder.
8. Turn on the position lights and
check that the new bulb is work-
ing.
9. Put the side marker assembly
back into the body. Push on the
front edge until it snaps into place.
Reinstall the mounting screw and
tighten it securely.
Maintenance
Lights
CONTINUED
Advertisement
Table of Contents
