Kia Sorento User's Manual & Installation Instructions page 6

ENGINE
START
STOP
Phillips Screwdriver, Trim Tool
N *Remove the Engine Start/Stop Button switch from the
O dash assembly by removing (1) phillips screw.
T *Using a trim removal tool, carefully pry outward to
E release the (2) pressure clips.
*Disconnect the connector attached to the Engine
Start/Stop Button switch.
Gear Selector Access Tab
Gear Selector
Handle
Pressure
Clips
Flat Screwdriver, Trim Tool
N
*Remove the gear selector access tab.
O *Push straight down with a fl at screwdriver and shift the
T gear selector into the drive position.
E
*Remove the gear selector handle by pulling it straight
up toward the headliner.
*Remove the center console/cup holder trim panel by
pulling upward at the cup holder area to disengage
the (6) pressure clips.
*Disconnect the connector and remove the trim panel
from the vehicle.
CAUTION! Ensure parking brake is set.
KIA Genuine Accessories (Vehicle Disassembly)
Pressure
Clips
Phillips
Screws
9
Pressure
Clips
11
Revision Date
Heater
Air Duct
Phillips Screwdriver
N
*Remove the (1) phillips screw securing the lower
O
heater air duct to the dashboard assembly.
T
*Remove the lower heater air duct from the vehicle.
E
Insert Center Fascia
Removal Tool Here
Push
Clips
Center Fascia Removal Tool
Center Fascia Removal Tool
P/N: 09840-1E100
*Disengage the (2) pressure clips and (4) push clips
N
securing the heated seat switch panel to the dash-
O
board assembly.
T
*Disconnect the connectors from the heated seat
E
switch panel and remove from the vehicle.
3/9/2012
Phillips
Screws
10
Push
Clips
Pressure Clips
(Located In Corners)
12
Page 6 of 27