Table of Contents
Advertisement
Configuring the remote modem/router
Adding the Remote Phone addressing
The Linksys Etherfast Cable/DSL router utilizes network address translation (NAT) to allow multiple
hosts to use the modem connection to the Internet and to provide limited security for those hosts. Follow
the following steps to configure the router. (Instructions for connecting to the configuration screen can
also be found in the Linksys Etherfast Cable/DSL Router User's Guide.)
1. On the user's PC open a Web browser and, in the address field, enter the IP address of the
modem. By default, that address is 192.168.1.1.
2. The Web browser will load the configuration screen and should ask for your password. Enter the
system password if required.
3. You should now be at the Setup menu. To allow the traffic bound for the phone through the router,
IP Forwarding will need to be configured. (Instructions for setting up IP Forwarding can also be
found in the Linksys Etherfast Cable/DSL Router User's Guide.)
• From the Setup screen, click on the Advanced tab; then, click on the Forwarding tab.
• On the first mapping, which is the first item in the list, enter the UDP port the Remote IP Feature
Phone will be using in the Service Port field.
• Under the Protocol column, choose UDP.
• Under the IP address column, enter the IP address of the phone.
• Click on Apply, then click on Continue. Then restart the router by powering it off, then on again.
When the NAT router comes back online, proceed with installing the Remote IP Feature Phone.
D.10
Remote IP Feature Phone Installation Manual
Advertisement
Table of Contents
