Panasonic RX550 Installation Manual page 25

LIGHTS: The lights auxiliary output is turned on/off with this line. If WIPE/LIGHTS/AP is
set to YES in the DISPLAY OPTIONS menu from the OPTIONS 2 menu then a * symbol
is displayed whilst the lights are on.
WASH/WIPE: The WIPE auxiliary output is turned on and the WASH auxiliary output is
activated for the time set in the OPTIONS menu. If WIPE/LIGHTS/AP is set to YES in the
DISPLAY OPTIONS menu from the OPTIONS 2 menu then a W is displayed whilst the
lights are on.
If ALARM STATUS is set to YES in the DISPLAY OPTIONS menu any open local alarm
inputs will be displayed. This is useful for remotely links to show any active/faulty alarm
input.
ALARM MENU: This item displays the ALARM MENU allowing the local alarms to be
enabled/disabled individually.
RX550DC ALARM MENU 1
ALARM 1
ALARM 2
ALARM 3
ALARM 4
ALARM 5
ALARM 6
ALARM 7
ALARM 8
NEXT
Use the UP and DOWN keys to select an alarm input. The Left or Right key will toggle
the state from ON/OFF. When the alarms have are configured correctly, select the NEXT
line to resume normal operation.
Alarm inputs are normally closed. The alarm is activated when contact open and the
receiver drives the head to the preset position corresponding to the alarm input.
PROG PRESETS: Allows preset positions to be programmed. The receiver will display
PROGRAM after the menu disappears. In this mode 'goto preset' commands are used to
program a preset position. Move the pan/tilt head and lens to the scene to be saved.
Please ensure that all the directions ARE NOT AT A LIMIT STOP as intermittent preset
operation could occur. Press PRE-POSI on the CURSOR/CAMERA CONTROL keypad
followed by the preset number required on the CAMERA/PRESET POSITION keypad.
Several preset positions can be programmed whilst PROGRAM is displayed. To return to
normal operation, go into the menu and set PROG PRESET to OFF. The receiver no
longer displays PROGRAM and normal control is resumed.
Note: preset functions require a preset head for pan/tilt positioning and a preset lens for
zoom/focus positioning.
Rx450AC Rx550DC MK3 Installation Manual - V19 30Sep05.doc
ALARMS
ON
Each local alarm input can be disable or enabled
ON
individually.
ON
Setting to OFF disables the alarm input
ON
and setting to ON enables the alarm input
ON
ON
ON
ON
Return to the AUTOPAN MENU
Page 25/28