Advertisement
8) VOLUME CONTROL
Adjust the volume control for the desired sound level. Turn clockwise to
increase and counter clockwise to decrease.
9) MONITOR POWER CONNECTOR
Insert the supplied power cable connector fi rmly until it is locked. To remove
the power connector, press in the clip and pull out the connector, while
holding the clip down.
Monitor's Power connector pin description
1
2
Pin No.
Description
3
Red: positive power
Green: R (reverse) gear power (optional)
2
1
Black: ground
3
10) CAMERA INPUT CONNECTOR
There are two mini DIN type connectors for the video camera inputs. Connect
the black and white video cameras to the monitor with the supplied cable.
The monitor supplies power to the camera.
Camera input connector pin description
2
3
Pin No.
Description
1
4
1
Power Supply
2
Audio Input
3
Image Reverse
4
Video Input
Outer shield of connector housing is ground
11) VCR JACKS
12) NORMAL/MIRROR OPTION
When the switch is in MIRROR position, the picture will be reversed. When the
switch is in NORMAL position, the picture will be normally displayed. Camera 1
and Camera 2 are operated individually.
6
Value
Tool
10 - 26 VDC
DVOM
10 - 26 VDC
CVOM
Value
Tool
12 VDC
DVOM
35 decibel
Tone generator
1.0V p-p
Oscilloscope
Tools Required for Troubleshooting
•
DVOM (Digital Voltmeter)
•
Phillips screw driver #1 and #2
•
3/32" allen wrench
•
Oscilloscope
•
Tone generator
•
Terminal tool kit
(such as Snap-On Tt600 if swapping Clarion
components for Safety Vision)
Operating and Troubleshooting Instructions
When you turn the ignition key to the accessory or on position, power is supplied
to the monitor. The system will turn on automatically when the vehicle is
shifted into reverse. Pushing the Power Button, will also manually activate the
system, which allows the operator to use the system while driving. The green
LED on the monitor will illuminate at that time.
Note the power of the monitor:
When you push the power switch to the S/B position, the monitor is placed
in a S/B mode. The monitor is not turned off until the ignition key is in the off
position.
See the following three pages for these conditions:
•
Monitor has power but no picture
•
Monitor screen is black
(see Flowchart B)
•
Monitor screen is white
(see Flowchart C)
(see Flowchart A)
7
Advertisement
