Installation - Whirlpool WRIBT24WA Owner's Instructions Manual

Steps for installation of The Butler Series (Alfred & Niles ranges):
Step 1: Remove the outer carton. Inspect the refrigerator to make sure
it has arrived safely at your home. In case you fi nd any transit damage to
your refrigerator, report to your dealer within 24 hours of delivery.
Step 2: After you unpack the refrigerator, select a well-ventilated spot
close to an electrical point. Allow suffi cient clearance for dispersion of heat,
preferably 6 inches (150 mm) at the back, on the sides and top.
Step 3: You can shift the refrigerator by raising the front slightly and sliding it on the rear castors.
Step 4: Rotate the two front levellers, provided below your refrigerator, clockwise
to raise the front and anticlockwise to lower it (refer fi g.1a). The front should
be slightly above the rear so that the door shuts gently when left open.
Things to keep in mind:
Ô
Keep the refrigerator away from direct sunlight and other high
temperature sources like oven and cooking range
Ô
Avoid damp, exposed locations
Ô
Avoid carpeted areas. A stable installation minimizes noise and prevents tilting
Ô
This appliance is not intended for use by person (including children)
with reduced physical, memory or metal capabilities lack of experience
& knowledge unless they have been given supervision or introduction
concerning use of appliance by a person responsible for the safety
Ô
Children should be supervised to insure that they so not play with the appliance
Ô
This appliance is not designed for use in vehicles or on board ships
or aircraft, additional requirements may be necessary
Ô
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualifi ed person in order to avoid a hazard
WHIRLPOOL REFRIGERATOR 200-299/300-399L/400-499L – INSTALLATION

INSTALLATION

Fig. 1a Fig. 1a
Fig. 1
Fig. 3
3