Kit Instructions
Leg Replacement Kit for
Airless Sprayers
- For Portable Spray Applications Architectural Paints and Coatings -
Models 24K632 and 24K633
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
Pressure Relief Procedure
To help prevent injection injuries, follow this
procedure when you stop spraying and before
you service or clean the sprayer, remove
parts, or repair leaks.
1. Turn Power switch OFF. Unplug sprayer.
2. Turn Spray/Prime valve to PRIME to relieve pres-
sure. Turn pressure control knob left (counterclock-
wise) to minimize pressure.
3. Trigger gun.
4. Put trigger safety in safety ON position.
NOTE: Leave Spray/Prime valve in the PRIME
position until you are ready to spray again.
If you suspect that the spray tip or hose is completely
clogged or that pressure has not been fully relieved
after following the steps above, VERY SLOWLY loosen
the tip guard retaining nut or hose end coupling to
relieve pressure gradually. Then loosen it completely.
Clear the tip or hose obstruction.
- Not for use in explosive atmospheres -
Model 24K632
ti11868a
3A1964A
EN
ti17726a
Model 24K633