Preparation - KPN USB-Modem 2 Quick Start Manual

Preparation

Requirements for the Computer
To use the KPN USB-Modem , the computer should meet the following requirements:
• USB Type A Receptacle, Compatible with USB . 0 High Speed.
• Operating System: Minimum Windows XP SP, Windows Vista or Windows 7 is installed.
• Apple Macintosh OS X 10.4 (Tiger), 10.5 (Leopard) and 10.6 (Snowleopard) are also supported. When the KPN
USB-Modem  is inserted in an Apple Macintosh, a new drive will be visible, from which the installation of the
Mac dashboard can be performed.
• Your computer's hardware system should meet or exceed the recommended system requirements for the
installed version of OS.
• Resolution for the display: 800 × 600 or higher.
Getting Your KPN USB-Modem 2 Ready
• See the pictures below.
• Slide the bottom-cover off the housing.
• Take a look at the picture in the housing of the USB-Modem, near the SIM-card slot. Insert the SIM-card into the
SIM-card holder, with the chip (gold-plated contacts) facing downwards. Please take note of the cutted edge
corner of the SIM-card.
• Now slide the bottom-cover back on the housing.
Inserting the microSD Memory-card (Optional)
• See the pictures above here.
• Slide the bottom-cover off the housing.
• Take a look at the picture in the housing of the USB-Modem, near the microSD card slot. Insert the microSD card
into the microSD card holder, with the gold-plated contacts facing upwards. Please take note of the cutted edge
of the microSD card.
• Now slide the bottom-cover back on the housing the microSD card into the KPN USB-Modem , as shown in the
following figure.
• Note: microSD memory-cards up to 3GB are supported.
Note: Do not remove the microSD card when it is being used. Removing the card during an operation may
damage the microSD card as well as the device, and data stored on the card may be corrupted.
4