Microphone Failure - Acer ICONIA Tab W500 Service Manual

Microphone Failure

If internal or external Microphones fail, perform the following, one at a time.
Figure 4-6. Microphone Failure
1.
Check that the microphone is enabled. Navigate to Start
Sound and select the Recording tab.
2. Right click on the Recording tab and select Show Disabled Devices (clear by
default). The microphone appears on the Recording tab.
3. Right click on the microphone and select Enable.
4. Select the microphone then click Properties. Select the Levels tab.
5. Increase the volume to the maximum setting and click OK.
6. Test the microphone hardware:
Select the microphone and click Configure.

Select Set up microphone.

Select the microphone type from the list and click Next.

Follow the on-screen prompts to complete the test.

7. If the Issue is still not resolved, refer to
Troubleshooting
Start
Check Mic to
MB cable well
connected?
Check Mic module?
Replace M/B
Online Support Information
0
Re-assemble Mic
No
cable to MB
Swap Mic module
No
and cable

Control Panel

Hardware and Sound
.
4-9
