Table of Contents
Advertisement
CIRCULATING FAN MODEL NBK-100
Optional for NC100 (Newmac Classic) and NCM120 (Newmac Classic II, Mobile) ONLY
NO OTHER CIRCULATING FAN IS CERTIFIED FOR THESE HEATERS
INSTALLATION: To install on heater, place outlet of fan box assembly into air duct located at bottom of rear panel.
Then attach fan assembly to rear panel with sheet metal screws provided. (Use #30 Drill). Make sure that the power
supply cord to the fan box is protected from possible damage.
OPERATION: Use 115V 60Hz 1PH AC current only.
1.
After the heater is in operation, and the toggle switch is in the automatic position, the circulating fan will operate. It
is controlled by a built-in heat sensing fan switch.
2.
The heater back panel must get hot to operate the fan switch, which controls the blower motor. The disc thermostat
fan switch must touch the rear panel when set in the automatic position.
3.
Normally it takes 30-45 minutes for the fan on the heater to operate after starting.
4.
The circulating fan may also be set for continuous operation by setting the switch in the "ON" position.
Oil the blower motor twice a year with (2) drops of S.A.E. 30 oil
Secure with sheet
metal screws
Classic Models NC100 and NCM120
Key No.
1
2
3
4
5
6
7
8
* Part Number 2220035 is a sub-assembly including all the parts indicated
Heater rear
Optional blower
NBK-100
Part No.
2220035*
2220035*
2220035*
2040033
2220035*
2220035*
2220035*
2040034
DESCRIPTION
Fan Housing Assembly
Inside Bracket
Fan Motor
Disc thermostat
Snap Bushing
Strain Relief
Cord with Plug
Toggle Switch
17
Hide quick links:
Advertisement
Table of Contents
