Table of Contents
Advertisement
5.
Remove the heater, cut the holes and prepare framing. Restore the integrity of the vapor barrier with suitable tape
and/or caulking.
6.
Install chimney ceiling support box JSC6CCSB (USA) or JM6CCS (Canada). Slide into opening level and nail
through box framing using four 2" spiral nails or equivalent per side.
7.
Prepare floor protector. Locate onto floor and cut 3-1/2" x 6" (89 x 152mm) hole.
8.
Position floor protector and install outside air duct through floor.
9.
Place heater in position. Be sure to lift heater in front and carefully slide over air duct.
10. Attach floor anchors. Drill 1/8: diameter holes and fasten to rear of heater base and floor with sheet metal screws
(#10 x ¾").
200
Stove Board
LOCATION AND DIMENSIONS OF AIR INTAKE
DUCT HOLE AND FLOOR PROTECTOR AS SEEN FROM TOP
Rain Cap
Spark Arrestor
Chimney section
Storm collar
TYPICAL CEILING SUPPORT BOX INSTALLATION
Mobile Home
Stove Board
Vapour Barrier
Insulation
INSTALLATION OF OUTSIDE AIR DUCT AS SEEN FROM SIDE
810
NCM120
Air duct location
150
3.5
90
3
7
4
195
Roof flashing
Overlap roof shingle
Ceiling Support Box
Optional seal/caulk with
non-combustible
silicone sealant
Heater
Floor Bracket
Floor Joist
Outside Air Duct
Screened End
13
450
cut out
ins
mm
Hide quick links:
Advertisement
Table of Contents
