JVC Mx-GT80 Service Manual page 21

Removing the CD loading mechanism
assembly(See Fig.10)
1. While turning the cams R1 and R2 assembly in the
arrow direction "h" ,align the shaft "i" of the CD loading
mechanism assembly to the position shown in Fig.10.
2. Remove the four screws F retaining the CD loading
mechanism assembly.
Removing the CD traverse mechanism
1. For dismounting only the CD traverse mechanism
without removing the CD loading mechanism assembly,
align the shaft "j" of the CD loading mechanism
assembly to the position shown Fig.11 while turning the
cam R1 and R2 assembly in the arrow direction "k" .
2. By raising the CD loading mechanism assembly in the
arrow direction "l", remove the assembly from the lifter
unit
Cam R1, R2 assembly
j
Fig.11
Removing the CD pick unit
1. Move the cam gear in the arrow direction "m" . Then,
the CD pickup unit will be moved in the arrow direction
"n" .
2. According to the above step, shift the CD pickup unit to
the center position.
3. While pressing the stopper retaining the shaft in the
arrow direction "o" , pull out the shaft in the arrow
direction "p".
4. After dismounting the shaft from the CD pickup unit,
remove the CD pickup unit
(See Fig.11 and 12 )
k
Arrow
(See Fig.13 )
Cams R1, R2 assembly
Arrow
h
i
F
F
CD loading mechanism assembly
Fig.10
Lifter unit
CD Pickup unit
Shaft
p
o
Stopper
Fig.13
MX-GT80/MXGT90
F
F
CD traverse mechanism
l
Arrow
Fig.12
n
CD loading
mechanism
m
Shaft
Cam gear
Shaft
Stopper
1-21