JVC Mx-GT80 Service Manual page 16

MX-GT80/MX-GT90
Removing the speaker (woofer)
Prior to performing the following procedures, remove
the front panel.
1. Remove the six screws D attaching the punch panel
on the front of the body.
Attention : When reassembling the punch panel,
need to put glue all around. this is
important to prevent vibration.
2. Remove the four screws E attaching the speaker
(woofer) on the front of the body.
3. Pull out the speaker (woofer) toward the front and
disconnect the wire from the two speaker terminals.
Removing the sub panel (See Fig.6 )
Prior to performing the following procedures, remove
the front panel.
1. Remove the six screws F attaching the sub panel on
the back of the front panel.
2. Remove the sub panel toward the front.
1-16
(See Fig.4 and 5)
D
Fig.4
Speaker (woofer)
E
Fig.5
Sub panel
F
Front panel
Fig.6
Punch panel
D
E
F