Rosen AV7700 Installation Manual page 10

Initial Test, Reassembly, and Pre-delivery Re-test
You will need to fully test the system to ensure it is working and connected to the vehicle properly.
The following steps will guide you through
Step 1: INITIAL TEST (Do this BEFORE you reassemble any trim panels)
a. Reconnect the vehicle battery if needed
b. Install batteries into the remote control, headphones and game controllers
c. Start the vehicle (ensure that it is safe to do so, there are no tools or people under
the hood)
d. Perform the following steps on each headrest to ensure proper operation:
•
Close and re-open the unit several times
•
With the display open, insert a DVD (in good condition) and select play
•
Check the audio on the IR headphones
• Press the Speaker button and adjust the vehicle radio frequency as needed to
check the audio
•
Select and play the internal games
•
Eject the disc
•
Turn off the vehicle and wait for the unit to turn off
e. If the system does not function properly, reset the system by pressing and holding
the reset
button located near the eject button
Step 2: REINSTALL all trim panels removed during the installation using care not to damage
any harnesses
Step 3: PRE-DELIVERY AND RE-TEST
a. Start the vehicle (ensure that it is safe to do so, there are no tools or people under
the hood)
b. Perform the following steps
•
Insert a DVD (in good condition) and select play
•
Re-check IR headphones and FMT audio
•
Eject the disc
•
Remove the protective films and clean the unit as needed
c. Place the Owners Information package in the glove compartment
d. Place the IR headphones, remote control and game controller in a convenient location
Rosen Entertainment Systems
AV7700 System Installation Guide
Installation Guide AV7700
this process
Copyright 2011 All Rights Reserved
STEP
8
AP2004-LX Rev A
Page 10