Installing Transmitter Batteries; Charging The Battery Pack - Traxxas 3602 User Manual

The following Traxxas High
Current Connector packages
are available from your hobby
dealer. When using adapters, be
careful not to exceed the current
rating of the Molex connector.
Part #3060 Part #3080 Part #3070
Single Male/ 2-Pack Female 2-Pack Male
Female
Part #3061 Part #3062
Male Charge Female Charge
Adapter Adapter
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries, or rechargeable
batteries such as NiCad or NiMH
(Nickel Metal Hydride) batteries
in your transmitter. Make sure
rechargeable batteries are
fully charged according to the
manufacturer's instructions.
If you use rechargeable batteries
in your transmitter, be aware that
when they begin to lose their
charge, they lose power more
quickly than regular alkaline
batteries.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red light)
to avoid losing control.
10 • TRAXXAS
THE TRAXXAS TQ RADIO SYSTEM

INSTALLING TRANSMITTER BATTERIES

Your TQ transmitter uses 8 AA batteries. The battery compartment
is located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab
and lifting the door up.
2. Install the batteries in the correct orientation as indicated in
the battery compartment.
3. Reinstall the battery door and snap it closed.
4. Turn on the transmitter and check the power indicator for
a solid red light.
If the power indicator light flashes, then the transmitter batteries
are weak, discharged or possibly installed incorrectly. Replace
with new or freshly charged batteries. The power indicator light
does not indicate the charge level of the battery pack installed in
the model.

CHARGING THE BATTERY PACK

The included charger can be used to charge the included battery pack.
The battery pack should be removed from the vehicle before charging.
Do not leave the battery unattended while charging. It is normal for
the battery to become slightly warm as it nears full-charge, but
the battery should never become hot. If the battery becomes hot,
disconnect it from the charger immediately. The included charger is
not for use with LiPo batteries.
1. Plug the charger into the wall. The LED on the charger should
glow green.
2. Connect the included battery pack to the charger output cord. The
LED will glow red indicating the battery is charging.
3. The battery should charge for approximately 8 ½ hours. The LED
will turn green when the battery is fully charged. Disconnect the
battery from the charger after charging.
2
1
Using Other Chargers
Another convenient option for charging the included battery
is an AC peak-detecting charger that plugs directly into an AC
wall outlet, such as the TRX EZ-Peak
special peak-detection circuitry that automatically shuts the
charger off when the battery is fully charged.
For faster charging, the included battery may be charged at
4 amps. The TRX EZ-Peak ™ is a 4 amp charger and will charge
the included battery in only 45 minutes!
Caution: Never use a 15-minute timed charger to recharge
your model's battery packs. Overcharging may result, causing
damage to the battery packs.
3
™ (Part #2930). It contains