Table of Contents
Advertisement
5
Safety and
Precautions
5.1
Environmental
The temperature and humidity ranges shown in
the specifications for this product must not be
exceeded.
This equipment must not be installed in an area
that is subject to a corrosive atmosphere,
excessive moisture or may allow water or other
liquids to come into contact with the unit or its
external connections.
In the close proximity of some radio frequency
transmitters, the signal to noise ratio of this
product may be reduced. If this occurs, re-location
of the equipment or the signal cables is
recommended.
5.2
ESD
This product contains static-sensitive devices.
Observe ESD precautions when working on the
equipment with the cover removed.
5.3
EMC
EMC compliance is dependent on this unit being
wired in accordance with these installation
instructions.
5.4
Electrical Safety
Always replace blown fuses with the
!
!
correct type and rating.
Ensure adequately rated cables are
!
!
used for power supply.
VAR8-ACU and Variants - Installation Guide
Issue: 02 complete, approved
Page 18 of 22
5.5
Lithium Battery
Danger of explosion if battery is
!
!
incorrectly replaced. Replace only
with the same or equivalent type.
Dispose of battery carefully to avoid
environmental
dispose of battery in a fire.
5.6
Unpacking and Handling
The
equipment
should
inspected immediately on receipt. If damage has
occurred please advise your carrier or supplier.
It is advisable to retain the original equipment
packing in the event that the equipment ever
needs returning for service.
Ensure that the name and address of the
Authorised Distributor from whom you purchased
the unit is recorded on the
page of this manual for future reference.
5.6.1
Packing for Repair
All electronics assemblies must be
!
!
properly packed in ESD protective
packing for transport, to prevent
physical and ESD damage. Use of
non-ESD protective packing for return
for repair or service will automatically
invalidate the warranty.
The filler material used for packing for
!
!
return for repair must be antistatic or
static dissipative, as this may come
into contact with exposed connectors,
wiring, or PCB assemblies. The use
of non-conductive filler material may
cause damage to the electronic
assemblies reducing their operational
life, or even destroying them, and it
will
automatically
warranty.
Advice on packing the product for return can be
provided by Application Solutions Limited.
damage.
Do
not
be
unpacked
and
"Service and
Warranty"
invalidate
the
Advertisement
Table of Contents
Need help?
Do you have a question about the VAR8-ACU Series and is the answer not in the manual?
Questions and answers