Related Manuals for Jobsite A45-X2
Summary of Contents for Jobsite A45-X2
- Page 1 Installation & User Guide For Powering Distributed Audio Systems A45-X2 TWO CHANNEL AMPLIFIER...
-
Page 2: Table Of Contents
A45-X2 TWO CHANNEL AMPLIFIER TABLE OF CONTENTS Features...1 Product Overview...2 Package Contents ...4 Preparing for Installation...4 Installation...5 Troubleshooting ...6 Specifications ...6 Warranty...7... -
Page 3: Features
FEATURES Stereo amplifier with 45 watts per channel Multiple turn-on modes Stable into low impedance loads (2.66 ohms) Installation friendly design 12V DC control output Individual input gain controls for each channel 3V - 30V AC/DC voltage-trigger Cascading outputs Automatic protection circuit with front panel indicator... -
Page 4: Product Overview
AC power outlet. (and that the master power switch is on). The red “Protect” LED indicates the amp has shut down because there is a fault in a speaker, the wiring, or with the A45-X2 itself. Cascade Outputs of the main input enable you to daisy chain multiple amplifiers. - Page 5 Green “Active” LED lights when the amplifier circuitry has been turned on by the Turn-On circuits. Level Adjustment screws enable you to preset the maximum system volume (or match levels with another amplifier). Binding posts for speaker connections. NOTE: AC receptable must be easily accessible.
-
Page 6: Package Contents
Removable AC power cord x 1 PREPARING FOR INSTALLATION Placement Place the A45-X2 on a flat level surface like a table or shelf. It should be placed upright so that its weight rests on the four attached feet. Placing the weight of the amplifier on the rear or front panel may result in damage to the amplifier's connectors and controls. -
Page 7: Installation
Wire stripper Wire labels INSTALLATION 1. Select an appropriate location for the A45-X2 2. Run all the necessary wiring to the A45- X2. Label the wires for future reference. 3. Strip 1/4" of insulation from the end of each speaker wire. Tightly twist the end of each wire until no frayed ends remain. -
Page 8: Troubleshooting
Level Adjustment Screws The front panel level adjustment screws allow you to adjust the level of the A45-X2, relative to other amplifiers in your system. Use a 1/8" slotted screwdriver to adjust the screws. If the A45-X2 is the only amplifier in... -
Page 9: Warranty
LIMITED WARRANTY JobSite Systems (“JOBSITE”), a Niles Audio Corporation company, warrants its passive products (those not requiring AC or battery power) to the original purchaser to be free of manufacturing defects in material and workmanship for a period of ten years from date of purchase. - Page 10 NOTES:...
- Page 11 NOTES:...
- Page 12 WWW.JOBSITESYSTEMS.COM © 2005 JobSite Systems. All rights reserved. JobSite, Pure Custom and Niles are registered trademarks of Niles Audio Corporation and the JobSite Logo is a trademark of Niles Audio Corporation. All other trademarks are the property of their respective owners. Some JobSite products (or components thereof) are manufactured under one or more U.S.