Specifications; Fcc Instructions To The User - Jobsite LSS-10 Installation & User Manual

SPECIFICATIONS:

Driver Complement
LSS-10: One 10" Long-Throw Front-Firing
Injection Molded Polypropylene Woofer
LSS-12: One 12" Long-Throw Front-Firing
Injection Molded Polypropylene Woofer
Amplifier Power
LSS-10: 90 Watts (rms), 125 Watts (peak)
LSS-12: 190 Watts (rms), 260 Watts (peak)
Frequency Response
LSS-10: 30 to 160 Hz, +/- 3 dB
LSS-12: 27 to 160 Hz, +/- 3 dB
Power Requirements
LSS-10 and LSS-12: 120 Vac; 230-240 Vac,
50/60Hz
Overall Dimensions (with grille)
LSS-10: 14.25" W x 15.25" H x 17.25" D
LSS-12: 14.25" W x 19" H x 19" D
Weight
LSS-10: 47 lbs, (21.3 kg) shipping weight
LSS-12: 57 lbs, (26 kg) shipping weight
Certification
• Meets FCC Part 15 and ICES-003, Class B
for USA and Canada
• CSA Listed and tested under UL/EN60065
standard
• CE compliant for the EU
• C-Tick compliant for Australia and New
Zealand
FCC INSTRUCTIONS TO THE
USER
This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
10
DS00490ACN-0 LSS-10_12.indd 10
can radiate radio frequency energy and
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving
■
antenna.
Increase the separation between the
■
equipment and receiver.
Connect the equipment into an outlet on
■
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
■
audio/video installer for help.
This equipment has been verified to comply
with the limits for a class B computing
device, pursuant to FCC Rules. In order to
maintain compliance with FCC regulations,
shielded cables must be used with this
equipment. Operation with non-approved
equipment or unshielded cables is likely
to result in interference to radio and TV
reception. The user is cautioned that
changes and modifications made to
the equipment without the approval of
manufacturer could void the user's authority
to operate this equipment.
5/23/06 2:13:34 PM