Panasonic WV-NP502E Installation Manual page 13

Angle adjustment
Be sure to loosen the screw of this product
mount bracket when the camera angle is
adjusted. If the camera angle is changed when
the screw is tight, excessive force is applied to
the camera mount bracket and camera, and
accordingly they may be damaged. Be sure to
tighten the screw securely after camera angle
adjustment.
Radio disturbance
When this product is used near TV/radio anten-
na, strong electric field or magnetic field (near a
motor, a transformer or a power line), images
may be distorted and noise sound may be pro-
duced.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.
Router
When connecting this product to the Internet,
use a broadband router with the port forward-
ing function (NAT, IP masquerade).
Refer to the Operating Instructions (PDF) for
further information about the port forwarding
function.
Heat dissipation
This camera is designed to dissipate heat
inside this product by intaking air from the
intake port on the rear to the exhaust port on
the top. Therefore, do not block those ports.
Approximately 5 cm of clearance from the
intake port and exhaust port to a wall shall be
left.
10BASE T/100BASE-TX
ACT LINK
MONITOR OUT
GND 4 3 2 1 ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/
AUX OUT/EXPOSURE OUT
Time & date setting
It is necessary to set the time and date before
putting this product into operation. Refer to the
Operating Instructions (PDF) on the provided
CD-ROM for further information about the set-
ting.
Intake port
AUDIO OUT MIC/LINE IN
INITIAL
SET
POWER
SD CARD/ABF
12V = IN
EXT I/O
ALARM IN 2/ALARM OUT
Exhaust port
13