Advertisement
SECTION XI. B: OPTIONAL HOT AND COLD PRESSURE WATER SYSTEM
Hot and cold pressure water is supplied to the galley sink, wash
basin, and shower.
Pressure System Operation:
Close foot pump selector valve. Turn pressure system switch on
distribution panel to ON position. Depress pressure pump priming
button located on galley bulkhead near sink. This will start pressure
pump. With button depressed, open one faucet until a steady stream of
water appears, then closed the faucet and repeat the procedure with
the other faucet. With both faucets closed, keep the button depressed
until pump stops automatically.
NOTE: If pump continues to run and a steady stream does not take
place, tank may be nearly empty. Select another tank and repeat
priming procedures.
Hot Water Heater:
This unit is located at the forward end of the starboard sail locker
(see separate literature for operation and maintenance).
Hot water is produced in two ways:
A. By running the main engine, part of its cooling water passes
through a coil in the heater thank, heating the water in the
tank.
B. If the boat is wired for dick side electricity, an electrical
heating element in the tank will heat the water.
Pressure Pump:
This pump is located at the forward end of the starboard sail locker.
(See separate literature for operation and maintenance).
Pearson 323 Owners Manual (1978 model year)
PEARSON YACHTS
OWNER'S GUIDE AND PROTECTION PLAN
Page 24 of 38
Advertisement
