Important Safety Instructions - SoundCraft         GicRac1000st User Manual

IMPORTANT SAFETY INSTRUCTIONS

CAUTIONS
• To avoid the risk of fire, replace the mains fuse only with the correct
type and value fuse, as marked on the rear of the product.
• ATTENTION: - Afin de réduire le risque de feu remplacer seulement avec
fusible de même type.
• MAINS VOLTAGE SELECTION
This setting is NOT User Adjustable.
The units are capable of operating at either 230V AC or 115V AC
mains voltages ±10%.
• REPLACING MAINS FUSE
Remove the mains lead from the connector. Use a small screwdriver
to unscrew the fuse carrier from its location to the left of the
mains power connector. Check the fuse is of the correct type and
value and replace if necessary; also check that the voltage rating
as marked on the rear panel is correct for the mains supply level
before switching the unit ON again.
If the mains fuse fails repeatedly this may be because an electrical
safety hazard exists. The unit must be taken out of service and
referred to the Soundcraft dealer from where the equipment was
purchased.
• THIS UNIT MUST BE EARTHED
Under no circumstances should the mains earth be disconnected
from the mains lead.
• ATTENTION: - Cet appareil doit être branché à la terre.
The wires in the mains lead are coloured in accordance with the following
code:
Earth / Ground: Green and Yellow Green and Yellow
Neutral:
Live:
4
UK & EU
Blue
Brown
US & CAN
White
Black