Enhanced Seat Belt Use Reminder System (Beltalert ) - Jeep 2009 Liberty Owner's Manual

48 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Enhanced Seat Belt Use Reminder System
(BeltAlert )
If the driver's or front passenger's seat belt has not been
buckled within 60 seconds of starting the vehicle, and if
the vehicle speed is greater than 5 mph (8 km/h), the
Enhanced Warning System (BeltAlert ) will alert the
driver or front passenger to buckle their seat belt. The
driver should also instruct all other occupants to buckle
their seat belts. Once the warning is triggered, the
Enhanced Warning System (BeltAlert ) will continue to
chime and flash the Seat Belt Reminder Light for 96 sec-
onds or until the driver's or front passenger's seat belt is
buckled. The Enhanced Warning System (BeltAlert ) will
be reactivated if the driver's or front passenger's seat belt
is unbuckled for more than 10 seconds and the vehicle
speed is greater than 5 mph (8 km/h).
BeltAlert Programming
The Enhanced Warning System (BeltAlert ) can be en-
abled or disabled by your authorized dealer or by
performing the following steps:
NOTE: Chrysler LLC does not recommend deactivating
the Enhanced Warning System (BeltAlert ).
1. With all doors closed, and the ignition switch in any
position except ON or START, buckle the driver's seat
belt.
2. Turn the ignition switch to the ON position, but do not
start the engine. Wait for the Seat Belt Reminder Light to
turn off and then proceed to the next step.
NOTE: You must perform the following steps within
60 seconds of turning the ignition switch to the ON
position.