Connecting To 10/100 And 10/100/1000 Ports - Cisco Catalyst 2950 Hardware Installation Manual

Connecting to 10/100 and 10/100/1000 Ports

Step 5
Step 6

Connecting to 10/100 and 10/100/1000 Ports

Catalyst 2950 Desktop Switch Hardware Installation Guide
3-32
Figure 3-30 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade
Screwdriver
1 9 2 0
2 1 2 2
2 3 2 4
Bale clasp
Grasp the SFP module between your thumb and index finger, and carefully
remove it from the module slot.
Place the removed SFP module in an antistatic bag or other protective
environment.
The 10/100 ports configure themselves to operate at the speed and duplex settings
of attached devices.They operate at 10 or 100 Mbps in half- or full-duplex mode.
If the attached devices do not support autonegotiation, you can explicitly set the
speed and duplex parameters.
The 10/100/1000 ports configure themselves to operate at the speed setting of
attached devices. These ports on Catalyst 2950T-24 switches operate at 10, 100,
or 1000 Mbps in full-duplex mode. The 10/100/1000 ports on Catalyst 2950 LRE
switches operate at 10 or 100 Mbps in either half- or full-duplex mode and
at 1000 Mbps only in full-duplex mode. If the attached devices do not support
autonegotiation, you can set the speed.
C a ta ly s
t 2 9 5 0
L R E
SE R IE
S
1
2
1
2
Chapter 3 Installation
78-11157-05