How It Works - Amcor D-850 Instruction Manual

ENGLISH
WARNING:
This appliance must be earthed.
Refer to the rating plate for
voltage and power input.
Your Amcor dehumidifier is supplied
with an electrical cable and an earthed
plug. Should it be necessary to replace
this plug at any time, you must use an
earthed electrical plug.
For U.K. only: If the attached plug
is unsuitable, cut it off and throw it
away. NEVER insert the severed
plug into an electrical socket or
outlet. Never use the plug without
the fuse cover fitted in place. If the
cover is lost you can purchase a
replacement from PENCON. The
replacement fuse is 10 Amps and
should conform to BS1362.
Check the wiring instructions and
diagram while refitting a plug.
Warning
There should be direct access to the electrical plug after connecting
the power!
Your Amcor dehumidifier controls Relative Humidity by passing the air through the
unit forcing the excess moisture to condensate over the cooling elements.
This condensate water then flows safely into a fixed drain.
The dried air then passes through a final heat exchanger where it is slightly warmed
and re-enters the room at a slightly elevated temperature.
The level of demoistering is set with the humidistat control.
5
Yellow/Green
(Earth)
Blue
(Neutral)
The BLUE (Neutral) wire should be
connected to the terminal in the plug
marked N or coloured black.
The BROWN (Live) wire should be
connected to the terminal in the plug
marked L or coloured red.
The GREEN/YELLOW (Earth) wire
should be connected to the terminal in
the plug marked E or
green.

How it works

10A Fuse
(U.K. only)
Brown
(Live)
Cable Grip
or coloured