Table of Contents
Troubleshooting
Related Manuals for Westwood V20
Summary of Contents for Westwood V20
- Page 1 S/T Series & V20/50 Westwood Garden Tractor © copyright Westwood Tractors 2004 Operator’s Manual Westwood Tractors, FREEPOST 3376, Plymouth, Devon, PL7 5ZY Tel: 0800 0720127 Fax: 0800 0720132 www.westwoodtractors.com • email@westwoodtractors.com 20050601...
-
Page 2: Contents Page
Contents Page Specifications (V20/50) Weight Turning Radius I, the undersigned A. Bennett of Westwood Tractors, Freepost 3376, Plymouth, Devon, England. V20/50 290 kg 99cm certify that the lawnmower: 59 kg Forward Speeds Comply to the provision of the directive 89/392/EEC amended by 98/37/EC and the regulations transposing it into national law. -
Page 3: International Symbols
Specifications (S & T Series) Safety Weight Transmission Congratulations on the purchase of your new Westwood ALWAYS remember – on Multi Bladed Garden Tractor. Machines, rotating one Blade can cause S1300/36 239 kg Tuff Torq K46 Hydrostatic the others to move. Take care. -
Page 4: Troubleshooting (Electrical)
Fuses (Fig 45, 46, 47 & 48) your Tractor: capabilities – it already allows you to mow The fuse box on your Westwood tractor is located under ✔ Disengage the Cutter Drive. large areas of grass very effectively in a the dashboard above the battery. - Page 5 If the battery has lost charge and will no longer hold Hour Meter & Service Light (Fig 5) the clutch in operation. Your Westwood Tractor is equipped with an hour meter, Low RPM Battery Charge Light IF THIS IS NOT THE CASE CONTACT YOUR TRACTOR which is linked to the service light.
- Page 6 Neutral (manual gearbox tractor only) and then simply pull the parking brake lever Removal of Rear Wheel (Fig 42 & 43) ‘D’ to the upright position (V20/50). On the S or T Series PARK BRAKE OFF PARK BRAKE ON ✔...
- Page 7 Differential Lock - V20/50 (Fig 11) ✔ That the Collector Net is not clogged. If so, wash or The V20/50 is fitted with a differential lock for maximum brush with a stiff hand brush. traction on slopes and slippery ground. The differential ✔...
- Page 8 DECK LEVEL SYSTEM FOR ‘S’ & ‘T’ SERIES Tractors from serial No. 50104 RPM (Fig 5) Your Westwood Tractor is equipped with an engine RPM Side to Side Level monitoring system to ensure that the correct engine speed This adjustment is best done with the deck in a position three up from its lowest cut –...
- Page 9 Troubleshooting (Cutter Levelling) Powered Grass Collector (PGC) The Cutter Deck should be set so that it is parallel to the Fitting the Net (Fig 18) Net Fitting surface it is cutting with a maximum variation from side to Fit the Net as shown in Figure 18 with the net rod in side or front to back of 3mm.
-
Page 10: Troubleshooting (Cutting)
The information contained on this, and the following The Cutter seems to Lose Power and the Sweeping Height Lever pages is given on the understanding that Westwood Belt Slips and Overheats Using the sweeper Height Lever select the position accepts no responsibility for work carried out by a appropriate to the conditions and the height of cut. -
Page 11: Routine Maintenance
– never attempt to sharpen or replace 2kg (4-5lb) pull the lock nuts are suitably tightened after adjustment. Belt them yourself. New Westwood blades are not tension should be set in the working position. expensive; it is good practice to ask your dealer to change them. - Page 12 When the drive is remove the Securing Bar (Figure 28 - F). dis-engaged using the hand brake, the park brake Remove the fifth wheel - G (V20/50 only). engages. This setting is adjustable but should be carried Deck Tension Rod...
Need help?
Do you have a question about the V20 and is the answer not in the manual?
Questions and answers