Subscribe to Our Youtube Channel
Related Manuals for Westwood S Series
Summary of Contents for Westwood S Series
- Page 1 S/T Series & V20/50 © Copyright Westwood Tractors 2004 Operator’s Manual Westwood Tractors, FREEPOST 3376, Plymouth, Devon, PL7 5ZY Tel: 0800 0720127 Fax: 0800 0720132 www.westwoodtractors.com • email@westwoodtractors.com 13DEC2005...
- Page 2 Westwood Garden Tractor...
-
Page 3: Contents Page
Contents Page Specifications (V20/50) Weight Turning Radius I, the undersigned A. Bennett of Westwood Tractors, Freepost 3376, Plymouth, Devon, England. V20/50 290 kg 99cm certify that the lawnmower: 59 kg Forward Speeds Comply to the provision of the directive 89/392/EEC amended by T1600-4WD T1800-4WD 98/37/EC and the regulations transposing it into national law. -
Page 4: International Symbols
Specifications (S & T Series) Safety Weight Transmission Congratulations on the purchase of your new Westwood ALWAYS remember – on Multi Bladed Garden Tractor. Machines, rotating one Blade can cause S1300/36 239 kg Tuff Torq K46 Hydrostatic the others to move. Take care. -
Page 5: Troubleshooting (Electrical)
Fuses (Fig 45, 46, 47 & 48) your Tractor: capabilities – it already allows you to mow The fuse box on your Westwood tractor is located under ✔ Disengage the Cutter Drive. large areas of grass very effectively in a the dashboard above the battery. - Page 6 Hour Meter & Service Light (Fig 5) IF THIS IS NOT THE CASE CONTACT YOUR TRACTOR Your Westwood Tractor is equipped with an hour meter, which is Choke DEALER. linked to the service light. The service light will come on 5 hours before your service is due.
- Page 7 This is an inevitable problem faced by around 5% of ‘A’. Reversing is controlled by footpedal ‘B’. Westwood users. Like all garden machinery, the most common cause of punctures are THORNS! Blackthorn, Hawthorn and Rose are usually the problem and will Moving Off / Reversing (Fig 6 &...
- Page 8 Troubleshooting (Grass Collecting) Controls cont. Grass Collection Freewheel Control - Hydrostatic (Fig 10) fig 10 If your Collector appears not to be picking up The natural braking of hydrostatic transmission means satisfactorily, check the following: that it is not possible to easily push or freewheel the ✔...
- Page 9 DECK LEVEL SYSTEM FOR ‘S’ & ‘T’ SERIES Tractors from serial No. 50104 RPM (Fig 5) Your Westwood Tractor is equipped with an engine RPM Side to Side Level monitoring system to ensure that the correct engine speed This adjustment is best done with the deck in a position three up from its lowest cut –...
- Page 10 Troubleshooting (Cutter Levelling) Powered Grass Collector (PGC) The Cutter Deck should be set so that it is parallel to the Fitting the Net (Fig 18) Net Fitting surface it is cutting with a maximum variation from side to Fit the Net as shown in Figure 18 with the net rod in side or front to back of 3mm.
-
Page 11: Troubleshooting (Cutting)
The information contained on this, and the following The Cutter seems to Lose Power and the Sweeping Height Lever pages is given on the understanding that Westwood Belt Slips and Overheats Using the sweeper Height Lever select the position accepts no responsibility for work carried out by a appropriate to the conditions and the height of cut. -
Page 12: Routine Maintenance
– never attempt to sharpen or replace 2kg (4-5lb) pull the lock nuts are suitably tightened after adjustment. Belt them yourself. New Westwood blades are not tension should be set in the working position. expensive; it is good practice to ask your dealer to change them. - Page 13 Routine Maintenance Routine Maintenance Engine Maintenance Engine to Cutter Drive Belt Tension fig 31 fig 26 Please refer to the engine manufacturer’s handbook The correct tension of the Cutter Drive Belt is critical. 2kg (4-5lb) pull enclosed with this manual. If incorrectly set it can lead to engine damage and invalidate warranty.
Need help?
Do you have a question about the S Series and is the answer not in the manual?
Questions and answers
westwood T1800 4wd, nem lehet előre hatra mozgatni motor nélkül?
No, the Westwood T1800 4WD cannot move forward or backward without the engine running. Movement requires engine power to operate the hydrostatic transmission.
This answer is automatically generated
I have a westwood S1400 . Battery is charged and connected, fuses checked. No ignition lights on turning key, but inside can see red-light under bonnet which also has green light when brake applied, but nothing happening when starting button pressed.
If a Westwood S1400 has no ignition lights when the key is turned, despite a charged battery and checked fuses, possible issues include:
1. A faulty ignition switch.
2. A disconnected or damaged wiring connection.
3. A blown fuse that was missed during inspection.
4. A malfunctioning safety switch, such as the park brake or seat switch.
If these checks do not resolve the issue, contacting a tractor dealer is recommended.
This answer is automatically generated
How do I replace the deck belt